Ultra Start 1270 series Installationsanleitung PDF herunterladen

INSTALL GUIDE

The system must be placed into Service Mode before any service work is started on the

vehicle. It is the sole responsibility of the vehicle owner to ensure that this is done. The

manufacturer accepts no liability or responsibility for accidental starting of the vehicle.

CARBON MONOXIDE - Never Start in an Enclosed Building (Garage, Carport etc...)

- The Hood Pin Safety Switch Must Always be Installed!

Warning!!

CARBON MONOXIDE MAY CAUSE SERIOUS INJURY, EVEN DEATH!

It is the sole responsibility of the user to place the system in Service Mode

when parking in an enclosed area ex: garage, partially enclosed area

ex: carport, or when the vehicle is being serviced.

NEVER INSTALL IN A MANUAL TRANSMISSION VEHICLE!!!

REV.2006.04

AUTOMATIC TRANSMISSION ONLY!

www.ultrastarters.com

Technical Support: 877-598-2100 ext 1

support@ultrastarters.com

1 2 3 4 5 6 ... 27 28

Inhaltsverzeichnis

Seite 1 - INSTALL GUIDE

INSTALL GUIDEThe system must be placed into Service Mode before any service work is started on the vehicle. It is the sole responsibility of the vehic

Seite 2 - Table of Contents

INSTALL GUIDE PAGE 10Wiring DescriptionsLOCK/ UNLOCK CONNECTOR (3pin red)

Seite 3 - IMPORTANT!

PAGE 11 INSTALL GUIDE

Seite 4

INSTALL GUIDE PAGE 12IMPORTANT! The system must be Tach Learned before remote

Seite 5

PAGE 13 INSTALL GUIDE

Seite 6 - Wiring Diagram

INSTALL GUIDE PAGE 14The system reset will clear any changes made to the Progr

Seite 7

PAGE 15 INSTALL GUIDE

Seite 8 - TYPICAL IGNITION SWITCH

INSTALL GUIDE PAGE 16Menu 1 - Press 1 Flash 2

Seite 9

PAGE 17 INSTALL GUIDE

Seite 10 - Wiring Descriptions

Menu 1- User Settings...continuedSetting 6 Sensor Enable/Disable (2270/4270/4265 series ONLY)1) Sensor Disabled 1 Flash/Chirp

Seite 11 - Important!

PAGE 19 INSTALL GUIDE

Seite 12 - Auto Tach/Tachless Learn

Table of ContentsTable of Contents Page 2Component/Feature List

Seite 13 - Important Tach Notes

INSTALL GUIDE PAGE 20Setting 1 Special Door Lock/Unlock Operations (Factory A

Seite 14 - System Reset

PAGE 21 INSTALL GUIDE

Seite 15 - Entering Program Mode

INSTALL GUIDE PAGE 22Setting 1 Low Idle Learn- Same function as doing the Qui

Seite 16 - Quick View Programming

PAGE 23 INSTALL GUIDE

Seite 17 - Menu 1- User Settings

INSTALL GUIDE PAGE 24Shock Sensor 2270/4270/4265 series Adjusting the shock se

Seite 18 - ...continued

PAGE 25 INSTALL GUIDE

Seite 19 - Menu 2- Additional Settings

87868587a3087868587a30LockUnlockVehicleLock/UnlockSwitchTo Control Relay or ActuatorGreenFused +12VBlueGroundNegative Type Door Locks 250maNegative Do

Seite 20 - Menu 3- Starter Settings

87868587a3087868587a30BlueGreenLockUnlockVehicleLock/UnlockSwitchTo ActuatorFused +12VxxCutCut87868587a30GroundDIAGNOSTICS1387868587a3087868587a30Blue

Seite 21 - - continued

If the remote starter does not activate when the start button is pressed the park lights will flash a diagnostic to indicate what shutdown input has b

Seite 22 - Menu 4- Tach Settings

Feature List- Control module - 2 Remote Transmitters - Antenna with built in Program Button a

Seite 23 - Remote Transmitter Learn

Recommended Installation ProceduresRemote car starters and alarms should be professionally installed. Review the installation and owner manuals and ac

Seite 24 - IMPORTANT SECURITY NOTES!

Recommended Installation ProceduresMounting The Control Module - Never mount the module in the engine compartment. Select a location under the dash t

Seite 25 - Install Notes

INSTALL GUIDE PAGE 6Wiring Diagram 1155332244661234567891011121314YELLOWYELLO

Seite 26 - Positive Type Door Locks

PAGE 7 INSTALL GUIDE

Seite 27 - Vacuum Type Door Locks

INSTALL GUIDE PAGE 8Wiring DescriptionsMAIN CONNECTOR (6pin) Pin

Seite 28 - DIAGNOSTICS

PAGE 9 INSTALL GUIDE