Ultra Start 33xx Series Installationsanleitung PDF herunterladen (Seite 7)

Wiring Diagram auxiliary connectors

Door lock output

Door unlock output

(-) When Running

Low Current (-) Output

Low Current (+) Output

Door lock module output only*

ACTIVE RF ANTENNA**

(-) 500ma Output

(-) 250ma Output

(-) 500ma Output

(+) 500ma Output

The jumpers control the output from the WHITE wire on the 6- pin harness. This is an

30amp relayed output. Place the jumpers in the following order to change the output.

If the jumper is in position #1 the output on the white wire will be 2nd Starter

If the jumper is in position #2 the output on the white wire will be 2nd Accessory

If the jumper is in position #3 the output on the white wire will be 2nd Ignition

*The factory default setting of the selectable output jumper is position #3.

Output on White wire Jumper position

Second Starter Position 1

Second Accessory Position 2

Second Ignition Position 3

Status Led’s

Program Button

**The antenna MUST be connected for the system to operate

* The centre pin of the keyless entry harness is not to be used for anything besides

plug-in devices such as the VP-1, DL-3, DL-7 and Data Bus Modules. Overloading

this output will damage the remote starter.

*Temperature Sensor (LT Models Only)

*Input Trigger To Start 3350 Series

*Not available on 3250 Series

Green

White/Violet

Blue

Black

Red

Jumpers

Page 7

2WAY REMOTE STARTER/ ALARM INSTALLATION MANUAL

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Keine Kommentare

Ultra Start 33xx Series Installationsanleitung Seite 7