Ultra Start 15xx Bedienungsanleitung PDF herunterladen (Seite 104)

TDC Ultra User’s Manual

13-6

The procedure to examine data for a count is very simple:

Move the highlight to Count. Press Change (#14 or 15) until the desired

count number is displayed. The date, time, and count type can be used to

ﬁnd a particular count if you are not sure of its count number.

If you want to look at all of the data, then move the highlight to Bins and

press Change repeatedly while reading the data displayed next to TOT. The

Bins number increments each time you press Change. After the last data

point in the interval is displayed, the Int number increments by one and the

Bins number automatically goes back to 001. You can go through all of the

data by continuously pressing Change.

If you want to look at a speciﬁc interval of data, then move the highlight

to INT and press CHANGE until the required interval is displayed. Then

follow the procedure outlined above to display the data.

The number of bins displayed is a function of the type of count, and the

number of keys used in the count. The table below shows the relationships

between the type of count and the number of bins used to store data, and

therefore the number of bins necessary to display the data.

# of Bins

Turning Movement & Roundabout Primary keys 16

Bin#1 is Key#1 If Bank1 keys used 32

Bin#2 is Key#2, etc. If Bank2 keys used 48

Classiﬁcation Scheme F 13

Bin#1 is Key#1 Scheme F/2 Direction 26

Bin#2 is Key#2, etc. User Deﬁned # of Classes

Gap 1 Direction 16

Bin#1 is Direction 1 Counted 2 Direction 32

Bin#2 is Direction 1 2-3 sec., etc. 2 Direction w/ Combined 48

Bin#17 is Direction 2 Counted

Bin#18 is Direction 2 2-3 sec., etc.

Bin#34 is Combined Gap 2-3 sec., etc.

Signalized Intersection Delay All 3

Bin#1 is Number Stopped

Bin#2 is Approach Stopped

Bin#3 is Approach Through

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 123 124

Keine Kommentare

Ultra Start 15xx Bedienungsanleitung Seite 104