Ultra Start 15xx Bedienungsanleitung PDF herunterladen (Seite 39)

3-7

If you press the TAB key a second time, the display changes to show

the totals for each of the secondary movements, BANK1 1-16. This is

designated by the number before the direction changing to a 2. If you

press the TAB key a third time, the display changes to show the totals

for each of the tertiary movements, BANK2 1-16, with the number

before the direction changing to a 3.

Press the TAB key a fourth time, and the display changes back to the

default status screen showing the time. You can continually press the

TAB key to cycle through the four screens (time, primary keys, sec-

ondary keys, tertiary keys).

At the end of each interval, the display automatically changes back to

the default screen, so you can check to see if it is time to end the study.

As soon as you press one of the movement keys, the display goes back

to the screen you were using when the interval ended. If you know that

you are not near the end of the study yet, you don’t have to look at the

display, just keep counting.

Ending the Study

When you get to the last interval, keep counting until the interval ends,

signaled by the triple beep. Once you hear this, turn the TDC Ultra

off.

Remember, the only way to stop a study is to turn the power off.

Video Mode Option

Standard Turning Movement Studies can also be performed in 'Video'

mode. Refer to page 2-15 for more information on this.

Chapter 3 — Standard Turning Movement Studies

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 123 124

Keine Kommentare

Ultra Start 15xx Bedienungsanleitung Seite 39